Jby6201 Manual Here
After cleaning, pump a small amount of machine oil through the system to prevent rust and keep seals lubricated. 5. Safety Precautions
JBY-6201 Installation Manual Request – Expert Help & Guide
Check for a clogged inlet strainer or a stuck intake ball valve. Tap the intake valve lightly with a wrench to loosen dried paint.
: A 16-pin terminal block handling power, ground, and direct analog speaker connections. jby6201 manual
| Error Code | Meaning | Solution | |------------|---------|----------| | | Hopper sensor error | Bills are not loaded correctly. Remove and fan bills. | | E2 | Double note detected | Bills are sticking. Clean rollers or reduce stack thickness. | | E3 | Chain note (overlap) | Slow down feed or clean sensors. | | E4 | Half note detected | Torn or severely wrinkled bill – remove it. | | E5 | UV sensor failure | Clean UV sensor lens. If persists, service required. | | E9 | Motor jam | Turn off, remove stuck bill manually, restart. | | C4 | Counterfeit alert (UV) | Bill failed UV test. Verify manually. |
| Error Code | Meaning | Solution | | --- | --- | --- | | E01 | [Insert error code meaning] | [Insert solution] | | E02 | [Insert error code meaning] | [Insert solution] | | [Insert other error codes] | [Insert error code meanings] | [Insert solutions] |
Open the pre-installed or TLink app on the stereo screen; this app serves as the processing bridge to automatically launch CarPlay or Android Auto interfaces. System Troubleshooting After cleaning, pump a small amount of machine
The JBY-6201 is a 2-DIN (Double DIN) Android head unit known for its:
Clean the rubber rollers with a damp cloth or specialized cleaner to maintain grip. Do not use solvents: Avoid using harsh chemicals. 6. Technical Specifications Counting Speed: ≥ 1000 pcs/min Banknote Size: 100 × 50 mm - 180 × 90 mm Hopper Capacity: ~ 200 bills Detection Method: UV/MG (varies by specific revision)
If you did not receive a paper manual, you can typically find instructions through the following methods: Tap the intake valve lightly with a wrench
To get the most out of your JBY6201 manual, follow these tips:
Swap the and Red (ACC) wire connections on the main harness. No sound output from speakers Master amp wire disconnected or speaker short circuit.
If you are not using an automatic digital CAN-Bus decoder box, you must manually program your analog steering buttons: Open the built-in app on the unit.
Some variants support multiple currencies. The JBY6201 manual will list supported currencies. By default, most are programmed for USD. Contact the manufacturer for firmware updates for other currencies.