Ericsson Ers 2460 Datasheet __hot__ -

-48 VDC nominal operational voltage (acceptable range: -38 VDC to -58 VDC).

Network operators face unprecedented demands for data capacity, low latency, and energy efficiency. To meet these challenges, Ericsson expanded its Radio System (ERS) portfolio with high-performance hardware designed to streamline macro-cell deployments and accelerate 5G rollouts. The Ericsson ERS 2460 is a core component of this modernized infrastructure, serving as a highly efficient, multi-standard radio unit optimized for dense urban and suburban environments.

The bottom connectivity panel of the Ericsson ERS 2460 provides secure, weatherized access points for fiber, power, RF, and control lines:

-40°C to +55°C ambient environment. 5. Software Features and Network Integration ericsson ers 2460 datasheet

Install Radio 2460 | PDF | Electrical Connector | Screw - Scribd

The Ericsson ERS 2460 is a remote radio unit (RRU) within the Ericsson Radio System (ERS) portfolio. It is specifically engineered for low-band frequencies, which are crucial for providing wide-area coverage and in-building penetration. Unlike traditional data networking switches, this device is designed to handle radio frequency (RF) transmission and reception for both 4G LTE and 5G NR networks.

Integrated Remote Electrical Tilt (RET) control via AISG (Antenna Interface Standards Group) compliance for dynamic beam optimization. 3. Physical and Environmental Attributes -48 VDC nominal operational voltage (acceptable range: -38

Now, as the sun sets over Oakhaven, the Radio 2460 sits silently on its pole, resisting wind loads of up to

: Multi-standard capability supporting GSM, WCDMA, LTE, and 5G (FDD).

Typically deployed for low-band configurations, explicitly supporting B8, B20, and B28B spectrum blocks. The Ericsson ERS 2460 is a core component

After careful evaluation, John's team decided to go with the second vendor's solution. The new RAN system was more flexible, scalable, and cost-effective than the other option.

: 2T4R Configuration (2 Transmitters, 4 Receivers). The 4-way receiver path uses receiver diversity to boost uplink throughput and coverage at the cell edge.

Shuts down transmitter elements during micro-seconds of zero traffic, cutting power waste during low-demand hours (e.g., late at night). Strategic Advantages for Network Operators

This hardware is a fundamental building block for operators looking to maximize their spectrum assets. Its primary function is to convert digital signals from the baseband unit into radio waves for transmission and to convert received radio signals back into digital data. By being placed remotely, often at the top of a tower, the RRU minimizes signal loss over coaxial cables, thereby enhancing overall network performance. The ERS 2460 is part of a larger strategy to build scalable, energy-efficient, and high-performance radio access networks (RAN).

Because the unit is IP65 rated, it does not require a shelter, air conditioning, or a concrete floor pad. It can be bolted directly to a rooftop or street pole, reducing both Capital Expenditure (CAPEX) and Operating Expenditure (OPEX).